Specification | 1Æ Filter | |||
Power ratings:
AC voltage ratings Optional DC Voltages |
1Æ 2 wire + E
Frequency Power System |
110, 200, 240, 275, 415 and 480
50 or 60 Hz TT, TN-S, TN-C, TN-C-S(MEN) |
||
Rated AC Current:
Optional ratings Filter Overload (non-overload protection) Current Crest Factor Overload/Short Circuit Protection Optional Protection method Operating Time |
Load Current
Current Overload Non-linear Current HW1-xxx only HW1-xxxC Nano Seconds |
001, 003, 005, 010, 016, 020,
032, 040, 063 150% for 1 minute 5:1 Peak/RMS No protection Device 1 x HRC Fuse 100% rated or 1 Pole C/Breaker 100% rated <1ns |
||
Filter Design:
Bandwidth Inductor Design Capacitor Type (Model HW1-xxx-P-xxx) |
Low Pass
150% Rated 300VAC X2 |
Surge / Transient / Noise Non Saturated Core
Tested Din Standards 40040 |
||
Internal Surge Diverters:
Primary Surge Diverters ratings Surge Waveform KA (8/20ms) Secondary Surge Diverters Ratings Surge Waveform KA (8/20ms) Modes of Protection** Primary and Secondary Surge Diverters **See SDM Brochure Maximum Continuous Operation Voltage Multipulse Capability Surge Performance (8/20ms) |
Field Replaceable
Standard Optional Standard Standard RMS AC Voltage SDM-140K/T SDM xxx-K/T |
No
40KA per mode** 80, 100, 140KA per mode** 40KA per mode** L~E+L~N and N~E 300VAC Yes Cat B (3KA) – 600V Cat C (3KA) – 800V See SDM Brochure |
||
Alarms
Breakdown Isolation Indication Panel |
Relay Contacts
Isolation Voltage LED Indication |
N.O. 5Amp.240VAC Rated
4KV Power and Surge Diverter Status (On = OK, Off = Fault) |
||
International Standards | Surge Testing | ANSI/IEEE C62.41-1991 AS/NZS 1768-1991 | ||
Abnormal Overvoltage Testing | HW1-xxx-P-xxx/T | UL1449 ed.2 | ||
Physical
Enclosure Mounting Cable Termination |
Temperature Range
Environmental rating Enclosure Colour Heat Loss Rear screw under cover Screw Connection Cable Entrance |
-10 to 80 °C, 0~90% humidity
Ip67 Polycarbonate Material Transparent Cover and Grey Base < 10 watts 4×4 Æ screw Flexible cable Bottom Gland plate |
||
Model
HW1-01 / 03 / 05 xxx-P-xxx/T HW1-10 / 16 xxx-P-xxx/T HW1-20 / 32 / 40/ 63 xxx-P-xxx/T |
Weight
1.5/1.6kg 2kg 2kg |
Terminals
Copper Lug 3.5mm Æ Screw Copper Lug 4mm Æ Screw Copper Lug 5mm Æ Screw |
Dimensions (Height x Width x Depth)
170mm x 80mm x 65mm 170mm x 140mm x 95mm 230mm x 140mm x 95mm |